A HAL2 Multiprocessor supports 18 in x 18 out audio, with 8 in x 8 out on balanced analog connections, another 8 in x 8 out through RADs, and 2 in x 2 out through AES3 digital audio. The HAL2 applies the same versatile Halogen software interface to venues that don’t need extensive expansion found in the HAL1x. It includes the same abilities to quickly design room combinations, paging systems, distributed music, and automixers with Rane’s “no virtual wiring needed” approach, but in a smaller I/O configuration to meet smaller budgets.

• DSP contains 4800 MIPS of processing power
• Ethernet 1000BASE-T with Zeroconf service discovery protocol for easy set up
• 8 analog balanced mic / line inputs on Euroblock connectors (green area)
  • Mic inputs have switchable +48 V phantom power
• 8 analog balanced line outputs on Euroblock connectors (orange area)
• AES3 stereo input (purple area)
• AES3 stereo output (purple area)
• Front panel signal and overload indicators for all inputs and outputs
• Four RAD Ports, each Port 2 in x 2 out plus control channel (blue areas)
  • RJ-45 shielded CAT 5e connections up to 150 meters (500 feet)
• Eight Digital Remote Ports (brown and blue areas) [DR can connect to RAD Ports]
  • RJ-45 shielded CAT 5e connections up to 300 meters (1000 feet)
• Four IR Remote Ports for IR2 Wall Sensors (lower gray area)
  • RJ-45 shielded CAT 5e connections up to 300 meters (1000 feet)
• Two Relay Outputs on Mini-Euroblock 6-pin connectors (upper gray area)
  • COM, NC & NO, 2 A, 48 V 60 W max switching power
• Four Logic Inputs on Mini-Euroblock 6-pin connectors (upper gray area)
  • Internal passive pull-up
• Unit Size: 2U, 3.5"H x 19"W x 8.25"D (8.9 cm x 48.3 cm x 20.9 cm)
• Unit Weight: 7 lb (3.2 kg)